557 Salmon Brook Street Granby CT 06035 
Mail to PO Box 677 Granby CT 06035 
Ph (860) 844-0004  fax (860) 653-9871

email [email protected]
No display on controller
What to do:
If the control display is blank when you look at it, but lights up when you touch a button or dial, You probably don’t have power to that outlet. You can check for power by plugging something else into the outlet. Most of the time, the problem is a tripped GFI. Many times the GFI breaker may be on another outlet that is close by. You can also check for a tripped breaker (at your electric panel).

The following controllers contain fuses: Hunter SRC, Toro Vision 1, Toro ECX and Greens keeper.

Note:
Many controllers contain a back up battery that will allow programing (with display) without a 110 volt supply. If this is the case, the display will go blank if left alone after a few minutes. The system will not operate without a 110 volt power supply.